Start engine to ensure all electrical components operate properly.
Press the Hazard lamp switch two times (ON, OFF) until vehicle instrument cluster indicates that is in Normal mode on the message center.
#Autel ford as built data how to#
How to turn of Factory Mode (2012 Ford Focus).
Note that with IDS hooked up, the vehicle might always start, but show faults in ABS TCM PCM communication bus. It will show corresponding message on the instrument cluster and will disable vehicles start.
After BCM reprogramming (or possible other modules too) vehicle might enter into a Transport or Factory Mode.
Place the key is shown on the picture.
Might need to do a TPMS Calibration also.
When using other key programming tools you might need two keys
using XTool APP I could just add one original key.
Copied original As Build data using FORScan and have written it to the used BCM.
Fixes multiple Vehicle Configuration and VIN Mismatch errors in various modules.
If ECM part number is “元S3 18 881B”, enter “元S3” in the first box and “B” in the second.
#Autel ford as built data manual#
It will ask to enter PCM part number ➱ Manual Vehicle Identification.
ECM IGN power that stays ON with ignition OFF (should be OFF).
#Autel ford as built data code#
After PCM programming, you need to program 4 letter ID code from ACT (Active Torque Coupling) solenoid bar (located at the rear differential).
P164D AWD ID Block Corrupted, Not Programmed.
PCM programming required dealer NASTF membership on Parameters Reset.
? ECM Replacement | 2017 Ford Escape 2.0L.
If ECM is used, To program 1 key, perform 10 min “security access” and click on “Program additional keys”.
(It will actually start one time if only one key is added, but will not start again due to not seeing second key).
If ECM is new, it doesn’t have any keys stored, so it will need 2 keys to start the vehicle.
It needs at least 2 different keys to be stored in the ECM to permit start
? ECM Replacement | 2005 Mercury Mariner.
Xtool, Autel, FORScan don’t have As Built options nor VIN Change option.
FJDS + Parameters Reset | 2009 Lincoln MKS
For some reason, didn’t need to change VIN, it was correct.
Performed “Add a Key”, said failed, but car started.
XTool APP ➱ Ford ➱ Immobilizer ➱ CAN (BCM) ➱ Type 3 ➱ Module Sync.
Relearn Configuration reprogrammed VIN also.
? ECM Replacement | 2014 Ford Transit, 2015 Ford Explorer.
ECM Replacment | 2010, 2013 Ford Transit.
ECM Replacment |FJDS | 2007 Ford Escape.
Programs ECM, FICM, and TCM ➱ Asks to reinstall FICM relay.
FJDS ➱ PMI➱ Asks if VIN is correct, say NO ➱ Type correct VIN ➱ Asks to remove FICM Relay (Fuel Injector Control Module).
ABS light said VIN mismatch, ECM had different VIN. Use ‘add key’ to avoid being asked to program minimum of 2 keys. ECM and Immobilizer Programming | Ford, Lincoln, Mercury